Formwork pipe, formwork pipe, (juvidur pipe) is used for formwork as protection of threaded rods facilitating their removal and at the same time acting as a formwork spacer. It is easily shortened on the spot to the desired length. A rosette is placed at the end of the pipe, which can be easily removed and replaced with a suitable plug after removing the formwork. It is produced in the length of 2 meters.

Koristi se za armiranje većih površina ploča horizontalne zone te za držanje težih armatura. Ima dobru stabilnost teodlična svojstva u toku armiranja. Posjeduje otvore na gornjoj i bočnim stranama što omogućava neometan protok betona.

Suitable for forming corners for formwork walls and beams (do not form sharp edges). They can be used for walls that require dilatation. It is used to form various joints in large continuous concrete surfaces. It is produced in the length of 2 meters, in two dimensions.

It is used to form corners for formwork walls and beams (they do not form sharp edges). They are easily fastened and removed thanks to the holes, which enables their maximum use. They are produced in the length of 2 meters.

PVC disk za pričvršćivanje u sistemu PVC membrana. Koristi se za tačkasto fiksiranje hidroizolacijskih membrana ili za fiksiranje geotekstila ispod hidroizolacije, te za pričvršćivanje toplinske izolacije i sistemu memrana za podrume i tunele. Postavljaju se u razmaku od 70 do 80 cm. Imaju visoku fleksibilnost čak i pri niskim temperaturama, kao i odlična dugoročna fizička i mehanička svojstva. Kompatibilni su sa PVC sintetičkim hidroizolacijama. Proizvod je atestiran od strane ovlaštenih institucija

It allows the vertical distance of the reinforcement from the wall formwork. The wide foot surface of the tongue increases load-bearing capacity and prevents twisting. The openings on the spacer allow an even flow of concrete.

It is applied to vertical zones and provides spacing between nets. Over 50 % savings unlike previous methods and no wire bonding required.

The purpose of the plastic plug is to close the openings in the pipes and formwork plates. The main function is to prevent spillage of concrete. There are two types of PVC plugs: ribbed and conical. Ribbed is also used as a waterproof plug.

The rosette with a cone is used at the ends of the pipe and is easily detached after removing the payment. It is used as an addition to the spacer tube to increase the surface area of the formwork wall.

It is placed at the point of composition of the reinforcing mesh. The installation of the spacer is simple and allows additional installation depending on the twisting of the network.

An annular spacer with reinforcements is used to hold large areas of the bottom of the reinforcement (larger surface of the reinforcement mesh). The ring is 200 mm in size.

Namijenjen je težim armaturnim mrežama sa jednom ili dvije zone. Veličina je 194×88 mm sa nožicama koje ostvaruju minimalan kontakt sa oplatom. Otvori na distanceru omogućavaju ravnomjeran protok betona.

Extra strong and solid washers are used to help lay the tiles on flat roofs and terraces. They are ideal for use on soft sand and insulation materials, thus providing protection against potential insulation damage.